%- store.address2 %><%}%>
<%- store.city %>, <%- store.state %> <%- store.zip %>
<%- store.phone %> <%}%>
Get Expert Advice
When setting up your router table or freehand router, there are two primary adjustments to make: the fence distance and the bit height. Our Center/Depth Gauge makes setting both easy and accurate. Just set the hairline indicator for the distance you need from the fence to the center of the bit, hook it onto the bit shank, then slide the fence over until it touches the gauge. To use it as a height gauge, simply set it at your bit height, lay the foot flat on the table and raise the bit until it touches the arm. Half-round notches let you register the gauge to the center of 1/4'' and 1/2'' shank router bits. Alternatively, you can use the ''depth'' portion to measure to the edge of the cutter, rather than the middle of the shank.