Lining up panels at a 90° angle while you drive nails or screws can be an exercise in frustration. Pieces tend to shift around, and your fingers are often too close to the business end of the nailer for comfort. That's where the Rockler Clamp-It Clips provide a welcome helping hand. They slip over the top corner of any two panels, holding them in perfect alignment while you drive the nails, screws or apply clamping pressure. They are available for two stock thicknesses: 1/2'' and 3/4''. The 1/2'' Clips are useful for drawer and small box construction, and also for cabinets with thinner 1/2'' casework, while the 3/4'' clips are ideal for cabinet construction with typical 3/4'' panel stock. For larger open cabinets and boxes, use the
Clamp-It? Corner Clamping Jig (#58918, sold separately) to secure the bottom corner, and to prevent the panels from tipping.
Holds the corners of boards and panels in perfect alignment while you drive fasteners
Makes cabinet, drawer and box assembly easier and more accurate
Choose clips for either 1/2'' (9/16'' max) or 3/4'' (13/16'' max) stock thicknesses
Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer. Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood